Filter
Top Products
PAGE 44
FIREBALL-MP INSTALLATION & USER’S GUIDE - M22002-01A1
CHAPTER 3 - GETTING STARTED
What Is The Setup Process?
Setting up a FireBall-MP is very easy once the FireBall Server is connected to an
ethernet network and properly congured.
Upon power on, FireBall-MP will try to automatically locate and connect to a FireBall
server. Please refer to your FireBall’s User’s Guide for instructions on properly
connecting the FireBall Server to an Ethernet network.
If a FireBall server is not located, the FireBall-MP will continue to scan the network until
a server is found. You should check your FireBall server’s power status and Ethernet
connetion. The FireBall-MP and FireBall Server must be on the same Ethernet network.
Note: FireBall-MP can only connect to one FireBall Server at a time.