Filter
Top Products
PAGE 140
FIREBALL-MP INSTALLATION & USER’S GUIDE - M22002-01A1
APPENDIX H - REMOTE CONTROL
2
When batteries need replacement,
the Remote will blink twice with
every key press. Simply replace
them and the remote control will
be restored to its full functionality,
including favorite settings.
Installing Batteries Into Remote
1. On the back of the Remote, push the tab and remove the battery cover.
2. Obtain two (2) fully-charged AA alkaline batteries. Match the + and – marks on the
batteries to the + and – marks in the battery case, then insert the new batteries.
3. Press the battery cover back into place. The tab should click when the cover is
locked.
4. Test the unit by pressing any key on the remote. If the batteries are inserted correctly,
the LED will blink each time you press a key.
Programming the Remote
The Remote can control up to 8 different components. Note that 3 of these are already
reserved for Escient's FireBall-MP, TuneBase 200, and PowerPlay products. Perform the
following instructions for each component you want controlled:
1. Turn on a component (e.g., VCR) and, if applicable, insert media, (e.g., cassette or
disc). NOTE: Please read steps 2-4 completely before proceeding. We recommend
highlighting or writing down the codes and device you wish to program before
moving onto step 2.
2. On the Remote, press a component key once (i.e., AUX, CBL, DVD, TV, RCV).
Press and hold CODE SET until the LED blinks twice, then release.
3. Use the Manufacturer’s Codes (last section in this appendix) to locate the type
of component and brand name and then enter the rst four-digit code for your
component. If performed correctly, the LED will blink twice.