Filter
Top Products
PAGE 30
FIREBALL-MP INSTALLATION & USER’S GUIDE - M22002-01A1
CHAPTER 2 - SETTING UP FIREBALL-MP
Connecting to Third Party Control Systems
Two RS-232 serial ports are available on FireBall-MP. You must use COM 2 to control
FireBall-MP from an external home theater or whole house control system.
FireBall-MP is compatible with AMX and Crestron RS-232 control systems. Additional
equipment may be supported. Please check the Escient website for an updated list of
compatible control systems.*
The RS-232 cable needed to connect FireBall-MP to any of these models is dependent
upon the model’s RS-232 pin conguration, and therefore the cable may have to be
custom-made. In most cases this will be a DB-9 Null Modem Cable (refer to Appendix
A).
u Find the RS-232 pin conguration for your Control System model in Appendix
A of this manual.
v Contact a Custom Cable Supplier to make a cable for your particular
conguration.
w Connect one end of this cable to the COM 2 port.
x Connect the other end of this cable to the RS-232 communication port on your
Control System.
2
* Control and Audio Distribution
system models that can integrate
with FireBall-MP are updated
periodically and may not be
reected in this particular manual.
Please consult your Dealer or the
Escient website if you wish to use a
control system not specied in this
manual.