Filter
Top Products
Notices 61
❍ Do not connect the AC adapter when the battery is not
installed. Otherwise, the P-2000 may be damaged.
❍ Use only the power source that meets the power
requirements indicated on the label attached to the
product. If you are not sure of the power supply
specifications in your area, contact your local power
company or regulatory agency.
❍ Make sure the total amperage of all devices plugged into
the power outlet does not exceed the power outlet’s
ampere rating.
❍ Do not use a damaged or frayed AC adapter.
❍ If you use an extension cord with this product, make
sure the total amperage of all devices plugged into the
extension cord does not exceed the cord’s amperage
rating.
❍ Never disassemble, modify, or attempt to repair the AC
adapter by yourself.
❍ Do not use power outlets controlled by wall switches or
automatic timers.
❍ Do not use power outlets on the same circuit as large
motors or other appliances that may cause voltage
fluctuations.
❍ Avoid using outlets on the same circuit as photocopiers
or air control systems that regularly switch on and off.
❍ Position this product’s power cord so that it will not be
stepped on or run over.
❍ Do not place any objects on the power cord and the AC
adapter.
❍ Keep the power cord straight at the ends and at the
points where it enters the transformer.
❍ The power cord should be placed to avoid abrasions,
cuts, fraying, crimping, kinking, and other damage.
❍ If you cannot insert the plug into the power outlet,
contact an electrician.
❍ Remove the AC plug from the outlet during lightning
storms.
❍ For US and Canadian users: Use the included power
cord or a 6 to 10 foot UL-approved type SPT-2 or
heavier type, 2
x 18 AWG cord with a 125 V 10 A plug
and 125 V 7 A connector.
Using the LCD
❍ The LCD panel on this product may contain a few
small bright or dark spots. These are normal and do not
mean that your LCD panel is damaged in any way.
❍ If the LCD panel on this product is damaged, contact
Epson.