Filter
Top Products
4
PREPARATION FOR USE
POWER SOURCE
This radio is designed to operate on normal 120V 60Hz AC power only. Do not
attempt to operate the radio on any other power source. You could cause damage
to the radio that is not covered by your warranty.
This radio should be connected to an AC outlet that is always ‘live’. Do not connect
it to an outlet that is controlled by a wall switch. When the power to the radio is
interrupted, the built in lithium battery takes over to maintain the time and alarm
settings. To maximize the life of the lithium battery keep the radio connected to a
‘live’ AC outlet at all times.
You will note that this system is equipped with a polarized AC power plug having
one blade wider than the other. This is a safety feature. If this plug does not fit into
your existing AC outlet, do not try to
defeat this safety feature by filing the
wide blade to make it fit into your
outlet. If this plug will not fit into your
outlet, you probably have an out-
dated non-polarized AC outlet. You
should have your outlet changed by
a qualified licensed electrician.
UNPACKING AND SET UP
• Remove the radio from the carton and remove all packing material from the
radio. We suggest that you save the packing material, if possible, in the unlikely
event that your radio ever needs to be returned for service. The original carton
and packing material is the only safe way to pack your radio to protect it from
damage in transit.
• Remove the CD protective card on the CD mechanism and any descriptive
labels or stickers on the front or top of the cabinet. Do not remove any labels or
stickers from the back or bottom of the cabinet.
• Note the serial number on the bottom of your radio and write this number in the
space provided on Page 2 of this manual.
• Place your radio on a level surface such as a table, desk or shelf, convenient to
an AC outlet, out of direct sunlight, and away from sources of excess heat, dirt,
dust, moisture, humidity, or vibration.
• Unwind the AC power cord and extend it to its full length. Unwind the FM lead
wire antenna and extend it to its full length.
AC Plug
AC Outlet
CKD8300_ib071403.p65 14/7/2003, 15:084