Filter
Top Products
15
PROGRAMMED PLAYBACK
You can program a CD to play only the tracks you want to hear, in the specific
order that you want them to play. A maximum of 20 tracks can be programmed.
Note: You cannot program the CD memory while the disc is playing. If the disc is
playing press the STOP button to stop playback. When the display is showing the
total tracks you can then program as follows:
1.) Press the PROGRAM/TIME ZONE button. The display will show “P 01” and
the PROGRAM indicator will begin to flash.
2.) Press the SKIP FWD/UP of the SKIP REV/DOWN button to select the first
track to be programmed. When the selected track number is flashing on the
display press the PROGRAM/TIME ZONE button again. The selected track is
entered in the program memory and the display advances to “P 02”.
3.) Repeat Step 2 until you have entered up to 20 tracks in the program memory.
4.) Press the PLAY/PAUSE button to begin programmed playback. The
PROGRAM LED indicator stops flashing and remains ‘On’. The display will
show the first programmed track number for a few seconds and then return to
the correct time.
5.) After all programmed tracks have been played the player stops but the program
remains in the memory and the PROGRAM LED indicator remains ‘On’. If you
press the PLAY/PAUSE button the programmed tracks will play again.
To cancel programmed playback press the PROGRAM/TIME ZONE button once
more. The PROGRAM LED indicator starts flashing again. While the indicator is
flashing press the STOP button to cancel the program. The PROGRAM LED
indicator goes ‘Off’.
Notes:
• You can program the same track to play multiple times if desired.
• After you press the PROGRAM/TIME ZONE button, you must select a track
number and press the PROGRAM/TIME ZONE button again within 10 seconds
while the PROGRAM LED indicator is flashing. If the indicator stops flashing,
the unit will exit the Program mode and the track number will not be entered in
the program memory.
CKD8300_ib071403.p65 14/7/2003, 15:0815