Filter
Top Products
10
ADJUSTING THE WAKE UP TIMES
Note: The Wake Up Times cannot be adjusted when the function selector is set to
‘CD’
Your Unit has two separate alarms that can be set and used independently. You
may use the alarms to wake two people at different times, or you may use one
alarm for weekdays and the other for weekend wake up times. The procedure for
adjusting the wake up time is the same for both Alarm 1 and Alarm 2.
1.) Set the AL (Alarm) 1 function switch to ‘ADJ’. The display will change from the
correct time to the Alarm 1 wake up time.
2.) Then press either the SKIP FWD/UP or SKIP REV/DOWN buttons to move
the display ahead or back to your desired wake up time.
3.) Release the SKIP FWD/UP or SKIP REV/DOWN buttons when the desired
wake up time is reached.
4.) Set the AL1 switch back to the ‘ON’ or ‘OFF’ position.
5.) Set the AL2 switch to the ‘ADJ’ position and repeat the above procedure to set
the correct Alarm 2 wake up time.
6.) Make sure that both alarm function switches are set back to either the ‘ON’ or
‘OFF’ positions.
Note: Be sure to observe the PM indicator to make sure you are setting the wake
up time correctly. If the PM indicator is ‘On’ the time displayed is PM.
If both of the Alarm switches are set to ‘ADJ’ at the same time the clock will
display the correct current time, not the Alarm 1 or Alarm 2 wake up time. So
be sure to set the AL 1 switch back to the ‘ON’ or ‘OFF’ position before
setting the AL 2 switch to the ‘ADJ’ position.
CKD8300_ib071403.p65 14/7/2003, 15:0810