Filter
Top Products
GETTING STARTED
Powering On and Off the unit
To power on the unit, press the POWER key on the
remote control or the ON key on the front panel of the
unit. The unit is now ready to use.
1
Notes on Power States
There are 3 power states for this unit:
OFF - The unit is unplugged with the battery removed. The
unit draws no power and cannot be turned on by the remote
control.
STANDBY - The unit is plugged in to the AC adapter or has
the internal battery installed and is turned OFF. The unit can
be taken out of standby by pressing either the POWER key
on the remote control or the ON button on the front panel.
The unit draws a slight amount of power to enable the
remote control receiving circuit.
ON - The unit is plugged in or on battery power and either
the POWER button on the remote control or the ON button
on the front panel has been pressed. The unit is ready to use.
Press the PUSH OPEN button on the front panel to open
the disc door.
1
Inserting a Disc
Labeling Side
Surface
Close the disc tray door and the unit will automatically
start playback of the disc.
3
19
GETTING STARTED
To power off the unit, press the POWER key on the
remote control or the OFF key on the front panel of the
unit. The unit is now in Standby Mode and will use a
small amount of power to receive signals from the
remote control.
2
Connect the power cord only when all other connections are
complete.
Insert the disc, being careful not to touch the playing
surface. Hold the disc by the sides and with your fore
finger through the hold in the middle and insert gently
into the tray.
2
POWER
LCD
GOTO
PROGRAM
BOOKMARK
SUBTITLE
ANGLE
DISPLAY
MENU
TITLE
MONITOR
SETUP
PBC
POWER
LCD
GOTO
PROGRAM
BOOKMARK
SUBTITLE
ANGLE
DISPLAY
MENU
TITLE
MONITOR
SETUP
PBC