Configuring Traps.......................................................................51
To add an SNMP trap by using the NetScaler command line....................51
Parameters for configuring SNMP traps ..........................................52
To configure SNMP Traps by using the configuration utility .....................52
Enabling Unconditional SNMP Trap Logging..........................................53
To enable or disable unconditional SNMP trap logging by using the NetScaler
command line......................................................................53
Parameters for unconditional SNMP trap logging ................................54
To enable or disable unconditional SNMP trap logging by using the
configuration utility.................................................................54
Configuring the NetScaler for SNMP v1 and v2 Queries....................................54
Specifying an SNMP Manager..........................................................54
To add an SNMP manager by using the NetScaler command line...............55
To add an SNMP manager by specifying its IP address, using the NetScaler
command line......................................................................55
To add an SNMP manager by specifying its host name, using the NetScaler
command line......................................................................56
Parameters for configuring an SNMP manager ..................................56
To add an SNMP manager by using the configuration utility ....................57
Specifying an SNMP Community.......................................................58
To specify an SNMP community by using the NetScaler command line ........58
Parameters for configuring an SNMP community string .........................58
To configure an SNMP community string by using the configuration utility .....58
To remove an SNMP community string by using the configuration utility........59
Configuring SNMP Alarms for Rate Limiting................................................59
Configuring an SNMP Alarm for Throughput or PPS..................................59
To configure an SNMP alarm for the throughput rate by using the NetScaler
command line .....................................................................60
To modify or remove the threshold values by using the NetScaler command
line .................................................................................60
To modify or remove the threshold values by using the NetScaler command
line .................................................................................61
Parameters for configuring an SNMP alarm for throughput or PPS .............61
To configure an SNMP alarm for throughput or PPS by using the configuration
utility ...............................................................................62
Configuring SNMP Alarm for Dropped Packets........................................62
To configure an SNMP alarm for packets dropped because of excessive
throughput, by using the NetScaler command line ...............................62
Citrix NetScaler Administration Guide
vii
