w show snmp alarm PF-RL-PPS-THRESHOLD
Example
> set snmp alarm PF-RL-PPS-THRESHOLD -
thresholdValue 70 -normalValue 50
Done
> show snmp alarm PF-RL-PPS-THRESHOLD
Alarm
Alarm Threshold Normal
Threshold Time State
Severity Logging
-----
---------------
---------------- ------------
------------- --------
1) PF-RL-PPS-THRESHOLD
70
50
N/A ENABLED
- ENABLED
Done
To modify or remove the threshold values by using the
NetScaler command line
w To modify the threshold values, type the set snmp alarm PF-RL-PPS-THRESHOLD
command and the parameters to be changed, with their new values.
w To remove the threshold values, type the unset snmp alarm PF-RL-PPS-THRESHOLD
command, followed by the –thresholdValue parameter, but do not specify any value
for the parameter.
Note: The normal-threshold value is automatically unset when you unset the high-
threshold value.
Parameters for configuring an SNMP alarm for throughput
or PPS
thresholdValue
The high threshold value, which triggers EVENT ALERTSTARTED. Minimum value: 1.
normalValue
The normal threshold value, which triggers EVENT ALERTENDED.
state
The current state of the alarm. Possible values: ENABLED, DISABLED. Default: ENABLED.
severity
The severity level of the alarm. Possible values: Critical, Major, Minor, Warning,
Informational. Default: SNMP_SEV_UNKNOWN.
Citrix NetScaler Administration Guide
61
