To configure a Web interface site for LAN users using HTTP
by using the command line
1. Add a Web interface site. Set Direct or Alternate or Translated for the
defaultAccessMethod parameter. At the NetScaler command prompt, type:
add wi site <sitePath> -siteType ( XenAppWeb | XenAppServices ) -
publishedResourceType ( Online | Offline | DualMode ) -kioskMode ( ON | OFF)
Example
add wi site WINS1 -siteType XenAppWeb -publishedResourceType
Online -kioskMode ON
2. Bind XenApp or XenDesktop farms to the Web interface site. At the NetScaler
command prompt, type:
bind wi site <sitePath> <farmName> <xmlServerAddresses> -xmlPort <value> -
transport ( HTTP | HTTPS) -loadBalance ( ON | OFF )
Example
bind wi site WINS1 XA1 10.102.46.6 -xmlPort 80 -transport HTTP
-LoadBalance OFF
bind wi site WINS1 XD1 10.102.46.50 -xmlPort 80 -transport
HTTP -LoadBalance OFF
3. Create a service that is a logical representation of the Web interface service
running on the NetScaler appliance. At the NetScaler command prompt, type:
add service <name> <IP address> <serviceType> <port>
Example
add service WI_Loopback_Service 127.0.0.1 HTTP 8080
For more information, see the “Load Balancing” chapter of the Citrix NetScaler
Traffic Management Guide at http://support.citrix.com/article/CTX128670.
4. Add an HTTP vserver. At the NetScaler command prompt, type:
add lb vserver <virtualServerName> <protocol> <IPAddress> <port>
Example
add lb vserver HTTP_WI HTTP 10.102.29.5 80
For more information, see the “Load Balancing” chapter of the Citrix NetScaler
Traffic Management Guide at http://support.citrix.com/article/CTX128670.
5. Bind the Web interface service to the HTTP vserver. At the NetScaler command
prompt, type:
bind lb vserver <virtualServerName> <serviceName>
Example
bind lb vserver HTTP_WI WI_Loopback_Service
For more information, see the “Load Balancing” chapter of the Citrix NetScaler
Traffic Management Guide at http://support.citrix.com/article/CTX128670.
Chapter 6 Web Interface
158
