Chapter 5
Configuring the Switch
25
48-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
ACL > IP based ACL
ACL > IP based ACL
Target Select the New ACL Name option and enter
an ACL name in the text field provided (with up to 16
characters). To add rules to an existing ACL, select the
ACL Name option and select an ACL from the drop-down
menu.
Action An ACL can contain any combination of permit or
deny rules.
Protocol Specifies the protocol type to match as TCP,
UDP or Others, where others indicates a specific protocol
number (0-255). (Options: TCP, UDP, Others; Default: ANY)
TCP Flags Specify the TCP flag bits in byte 14 of the TCP
header by selecting Set or Unset from the drop-down
menus. The following TCP flags may be specified:
Urg Urgent pointer
Rst Reset
Ack Acknowledgement
Syn Synchronize
Psh Push
Fin Finish
Source/Destination Port (0-65535) Source/destination
port number for the specified protocol type. (Range: 0-
65535)
Use the Source/Destination IP Address option to apply the
ACL rule to an IP address or select the Any option to apply
the rule to all IP addresses.
Source/Destination IP Address Enter a source or
destination IP address.
•
•
•
•
•
•
Wildcard Mask Enter the Wildcard Mask for the Source/
Destination IP addresses.
Match CoS Packet priority settings based on the following
criteria:
DSCP DSCP priority level. (Range: 0-63)
Precedence IP precedence level. (Range: 0-7)
Then click the Add to List Button
To remove an ACL rule, select an ACL rule from the table
and click Remove.
When all rules are removed from the ACL the ACL is also
removed.
ACL > MAC based ACL
ACL > MAC based ACL
Target Select the New ACL Name option and enter
an ACL name in the text field provided (with up to 16
characters). To add rules to an existing ACL, select the
ACL Name option and select an ACL from the drop-down
menu.
Action An ACL can contain any combination of permit or
deny rules.
Use the Source/Destination MAC Address option to apply
the ACL rule to a MAC address or select the Any option to
apply the rule to all MAC addresses.
Source/Destination MAC Address Specify a MAC
address (for example, 11-22-33-44-55-66).
Source/Destination Wildcard Mask Hexadecimal mask
for source or destination MAC address.
VLAN ID Specify a VLAN ID. (Range: 1-4094)
•
•
