12
Configuration Using the Console Interface
48-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
Chapter 4
Back to Main Menu
Select Back to Main Menu if you want to return to the
main menu.
Port Status
The Port Status screen allows you to view the status of
a port. The Port, Enable, Link Status, Spd/Dpx, and Flow
Control are displayed.
Port Status
Ports 1 through 48 are Ethernet RJ-45 ports and are
all 10/100 ports. Ports G3 and G4 are shared with the
miniGBIC ports. If there is a connection to one of the
miniGBIC ports then the corresponding Gigabit RJ-45 port
cannot be used.
Port Configuration
You can use the Port Configuration screen to enable/
disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex
mode, and flow control.
Port Configuration
Enable Allows you to manually enable or disable an
interface. You can disable an interface due to abnormal
behavior (for example, excessive collisions), and then
enable it again, once the problem has been resolved. You
may also disable an interface for security reasons.
Auto-negotiation (Port Capabilities) This option enables or
disables auto-negotiation. When auto-negotiation is enabled,
you need to specify the capabilities to be advertised. When
auto-negotiation is disabled, you can force the settings for
speed, mode, and flow control. The following capabilities are
supported.
10half Supports 10 Mbps half-duplex operation
10full Supports 10 Mbps full-duplex operation
100half Supports 100 Mbps half-duplex operation
100full Supports 100 Mbps full-duplex operation
1000full Supports 1000 Mbps full-duplex operation
Default: Auto-negotiation enabled; Advertised capabilities
for 100Base-TX – 10half, 10full, 100half, 100full; 1000Base-
T – 10half, 10full, 100half, 100full, 1000full; 1000Base-SX/
LX/LH (SFP) – 1000full; 100Base-FX (SFP) – 100full
Speed/Duplex Allows manual selection of port speed and
duplex mode (that is, with auto-negotiation disabled).
Flow Control Allows automatic or manual selection of
flow control.
PoE Configuration
The PoE Main Menu screen displays three menu choices
and a back option:
PoE Main Menu
System PoE Configuration
Port PoE Status
Port PoE Configuration
•
•
•
•
•
1.
2.
3.
