Chapter 5
Configuring the Switch
15
48-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet
System Information
Serial Number The serial number of the Switch is
displayed.
Model Name The model name of the Switch is
displayed.
Hardware version The current hardware version is
displayed.
Boot Version The current boot version is displayed.
Firmware Version The current software version is
displayed.
System Location Displays the location of the system if it
has been defined.
System Contact The name of the administrator will
appear here if it has been defined.
System Uptime Length of time the management agent
has been up.
Current Time Displays the current time.
PoE Information
Maximum Available Power Displays the maximum
power that can be supplied to a connected PoE device.
System Operation Status Displays the operational status
of the Power over Ethernet mechanism.
Mainpower Consumption Displays the current number
of watts that the Switch is providing to PoE devices.
Setup > Network Settings
Setup > Network Settings
The Network Settings screen allows you to edit the
following information.
Identification
System Name Specifies the name of the Switch. Enter
the name into the text field provided. By default, a system
name is not defined.
System Location This field is used for entering a
description of where the Switch is located, such as 3rd
floor.
System Contact Enter the name of the administrator
responsible for the system.
Object ID The system object identifier is displayed here.
Base MAC Address Physical address of a device mapped
to this interface.
IP Configuration
To manually configure IP settings, you need to set an IP
address and subnet mask compatible with your network.
You may also need to establish a default gateway between
the Switch and management stations that exist on another
network segment.
An IP address may be used for management access to the
Switch over your network. You may also need to establish
a default gateway between the Switch and management
stations that exist on another network segment.
Management VLAN ID of the configured VLAN (1-4094,
no leading zeroes). By default, all ports on the Switch are
members of VLAN 1. However, the management station
can be attached to a port belonging to any VLAN, as long
as that VLAN has been assigned an IP address.
IP Address Mode Specifies whether IP functionality is
enabled via manual configuration (Static), Dynamic Host
Configuration Protocol (DHCP), or Boot Protocol (BOOTP).
NOTE: If DHCP/BOOTP is enabled, IP will not
function until a reply has been received from the
server. Requests will be broadcast periodically
by the Switch for an IP address. If the mode is
set to DHCP/BOOTP and a server is not available,
you can reconfigure the settings by connecting
the console interface directly to a computer.
Select the IP Address Mode using the drop-down
menu. Selecting Static will allow you to enter a static IP
address, subnet mask and default gateway using the text
field provided. Selecting BOOTP or DHCP disables these
text boxes and auto assigns an IP address. The default
setting is Static.
Host Name Assign a host name to the switch.
