Filter
Top Products
21
Appendix A - Error Messages
Following is a list of error messages that may be displayed.
No HARD DISK !!
This would appear during the power up sequence if no hard disk could be found.
Check that the power cable is correctly installed on the hard disk, and that the data
cable is correctly connected between the hard disk and the copy electronics. If in
doubt, contact your TEAC authorised dealer.
!! ERROR !! No Writers Found
This suggests that either no writers are installed, or that they are incorrectly installed.
Check power to each recorder, and check that the SCSI cable is correctly connected to
each drive, and to the copy electronics.
For SCSI systems, ensure that every writer on a given bus has a unique SCSI ID. If
two SCSI devices have the same ID, they will not work.
For IDE systems, ensure that only one drive be connected to each cable.
!! ERROR !! - No disc in drive
The system cannot detect a Master disc in the drive. If there is a master in the drive,
the disc may require cleaning.
!! ERROR !! - Disc in drive appears to be blank
The system tried to read a Master, which appears to be blank. Check the Master disc
and try again. Again, the disc may require cleaning.
User Data Corrupt
The user set-up (including Duplication Options) has become corrupt. The system will
automatically reset the options to the factory settings.
Job Cancelled
The user pressed the stop key.