Filter
Top Products
11
This function re-initialises the hard drive directory structure. It should be run
anytime a new hard drive is installed in a system. This function can also be used
to quickly erase all images in the hard drive.
NOTE:
This function does not actually remove Images from the hard drive and is not a
secure erase of the image data. It simply marks all the hard drive as unused and
available for new images. The data remain on the disk until overwritten by
another image file.
Firmware Utilities
Firmware Utilities allows the firmware used by the TCP system controller,
Autoloader controller and the drives to be updated (depending on the drive model).
Load System F/W
The system software that is used by the TCP to copy discs may be updated from
time to time, to add new features or support for new drives. The following
functions are used to update the firmware in the machine.
Load Loader F/W
Very occasionally, there may be an updated version of loader firmware available
for download. This is the menu entry that will allow you to load this onto your
autoloader. For the reliability of your system, only install TEAC released
firmware onto your system.
VERY IMPORTANT NOTE:
It is VERY IMPORTANT that you do not turn off the power while this function
is running. Turning off the power before the Duplicator has completed the
drive upgrade may leave your Disc Publisher in a state where it no longer
functions correctly. If you are in any doubt about this, please contact TEAC, or
an authorized TEAC distributor before using this feature.
Note: Some CD Copy protection schemes rely on ‘bad blocks’, and so scanning a
copy protected CD will often reveal uncorrectable C2 errors.
Audio Compilation
This feature allows the creation of audio compilation CDs from existing masters.
You can compile tracks from different master CDs into an image on the hard disk,
that you can then create copies from.