Filter
Top Products
14
Available only on TrueNET enabled systems, setting this to YES will cause the
system to enter network mode immediately on power on. Set to NO, the system
will run in stand-alone mode.
Multi Image HD
If set to YES discs read will be named and stored on the hard drive for future
use. Many CD images can be kept on the hard drive.
If set to NO a master read will still be saved to the hard drive but it will have no
name and will be overwritten by the next master read.
NOTE:
If Multi Image HD is enabled and Images are stored on the hard drive and then
the Autoloader is operated with Multi Image HD set to NO all the previous
images may be lost.
Ask Quantity
If set to YES, the user will be prompted for a quantity at the start of a copy /
compare job. If set to NO, the machine will copy until told to stop by pressing
and holding the STOP key.
Copy Index Marks
Default setting for this should be Yes
Async Copying
When set to YES, the system will run the drives asynchronously. Setting this to
NO will increase the time taken for duplication, since all drives must be loaded
or unloaded before duplication can continue (synchronous operation).
Async Jobs
Default Setting for this should be No
Check Blank Size
If set to YES, the copier will check that blank disc has enough free space on it
before starting to write. If set to NO, the copier will attempt to write the image to
the disc, even if the blank is not large enough. This may mean that copies are
rejected, because the blank disc did not have sufficient room. This feature allows
discs to be over burned.
Warn Need 80min
If this option is set to YES, a warning message will appear each time you start a
copy job, with a master image greater than 74 minutes. This prompt is to remind
the operator that the image will not fit on a 74 minute CD-R disc.