Filter
Top Products
57
|
3 Slide REC.
“REC” appears in the display
and recording starts after
about 2 seconds.
If you have started recording
from the FWD side, recording
will switch to reverse side
automatically at the end of the
FWD side.
To stop recording
Press p•RADIO OFF on the main
unit or press the jog lever on the
remote control.
To reduce noise while
recording AM programs
Set the ISS (Interference Suppress
Switch) to the position that reduces
noise the most.
To monitor the recording
sound
You can monitor the recording
sound through headphones/
earphones. Adjust monitoring level
using VOL.
Note
•You may hear some noise in the
monitor sound in the RV, MB, or
GRV mode, but this does not affect
recording.
Notes on recording
•The recording level is fixed.
•Sound emphasis (RV, MB, or GRV),
AVLS and Dolby B NR settings do
not affect recording.
•Actual recording will start about 2
seconds after you slide REC. Slide
REC about 2 seconds before the
moment you want to start
recording, or you will miss the
beginning of your recording.
•When recording on both sides,
recording will not be made for
about 10 seconds while the tape is
switching sides.
•Do not use a CrO
2 (TYPE II) or
metal (TYPE IV) tape. If you do, the
sound may be distorted when you
play back the tape, or the previous
recording may not be erased
completely.
•Do not connect or disconnect the
earphones to/from 2REMOTE
while recording from the radio. The
recording condition may change
abruptly, or noise may be recorded.
•To avoid noise interference, do not
place it near a lamp cord or a
fluorescent lamp when recording
with the microphone.
•If a howling effect occurs, turn
down the volume.
•All other operation cannot be made
while recording. For other
operation, stop recording first.
To prevent a tape from
being accidentally recorded
over
Break off the tabs from side A
and/or B. To reuse the tape for
recording, cover the tab hole with
adhesive tape.