Filter
Top Products
Chapter 6 Adjusting and Setting Through Menus
Chapter 6 Adjusting and Setting Through Menus 87 (GB)
Icon/Menu
Submenu
Setting
(page)
V
VIDEO SET
PB LEVEL
(page 68 (GB))
Adjusts the output video signal levels. (This is available only when the mode is playback,
playback pause, slow playback, cue, or review.)
SETUP: Switches the luminance signal setup level (0% or 7.5%). (This item is only for the
DSR-45. The setup level for the DSR-45P is fixed to 0%.)
Y LEVEL: Adjusts the Y signal level of the component signals. (If you change this, the Y
signal level of the composite video and S VIDEO will also be changed.)
R-Y LEVEL: Adjusts the R-Y signal level of the component signals. (If you change this,
the chrominance level of the composite video and S VIDEO will also be changed.)
B-Y LEVEL: Adjusts the B-Y signal level of the component signals. (If you change this,
the chrominance level of the composite video and S VIDEO will also be changed.)
CHROMA: Adjusts the chrominance level in the composite signals.
Notes
• You can adjust the video levels only while playing the tape.
• Adjust the video levels by looking at the bars (except SETUP). (The triangles under the
bars are displayed in green when the settings are set to the factory preset values.)
• The SETUP default is 0%. Other defaults are their center values.
• The output video signals can be adjusted only for VIDEO OUT, COMPONENT OUT, or S
VIDEO OUT.
• Set SETUP to 7.5% only if the tape has been recorded at 0% and you want to play back
the tape at 7.5%. If you play back a 7.5% tape at the 7.5% setting, the tape will not be
played at the proper brightness. If you set SETUP at 0% and if you play back a 7.5% tape,
the tape will be played at 7.5%. (You cannot play the tape at 0%.)
EXT SYNC Switches the externally synchronized playback setting.
OFF : No external synchronization
ON: External synchronization
Notes
• It may take three or more seconds until a stable image is output in the externally-
synchronized playback mode.
• In the externally-synchronized playback mode, jitter may appear on the MONITOR VIDEO
output or on the LCD monitor image. Use the VIDEO OUT connector to output an
externally-synchronized image. Set this item to OFF when you use the MONITOR VIDEO
output.
H PHASE
(page 66 (GB))
Roughly adjusts the sync phase in the externally-synchronized playback mode.
Press the J/j buttons to move the bar and press the EXEC button to select. (The triangle
under the bar is displayed in green when the setting is set to the factory preset value.)
Notes
• You can adjust this item only in the externally-synchronized playback mode.
• If you change this item, the H PHASE F value will be set to the factory preset value.
H PHASE F
(page 66 (GB))
Finely adjusts the sync phase in the externally-synchronized playback mode.
Press the J/j buttons to move the bar and press the EXEC button to select. (The triangle
under the bar is displayed in green when the setting is set to the factory preset value.)
Notes
• You can adjust this item only in the externally-synchronized playback mode.
• If you change the H PHASE value, this item is set to the factory preset value.
(Continued)