Filter
Top Products
Chapter 3 Using the Unit as a Player in an Editing System
Chapter 3 Using the Unit as a Player in an Editing System 49 (GB)
Connections for a Cut Editing System
The following figure shows a cut editing system
configuration that uses this unit as the player.
For details of connecting devices other than the DSR-45/
45P, refer to the instruction manual of each device.
Note
The preroll time of the setting on the editing controller
is required to be more than five seconds.
DSR-45/45P (player)
VIDEO OUT 1
S VIDEO OUT 5
COMPONENT OUT
MONITOR VIDEO
AUDIO OUT CH-4 4 AUDIO IN CH-4
AUDIO OUT CH-3 4 AUDIO IN CH-3
AUDIO OUT CH-2 4 AUDIO IN CH-2
AUDIO OUT CH-1
RS-422A
4 AUDIO IN CH-1
REF.VIDEO
OUT
REF.VIDEO OUT
1
1
REF.VIDEO
IN
REF.VIDEO INPLAYER
RECORDER 2
1
2
3
MONITOR
AUDIO
REF.VIDEO
OUT
MONITOR
AUDIO
MONITOR
VIDEO OUT
REMOTE
31
3
VIDEO IN
S VIDEO IN
VIDEO IN
REF.IN
1
Y, R-Y, B-Y IN
Source video
monitor
Audio
input
Video
input
Reference
video signal
generator
Editing controller
Recorder
Main video
monitor
Connect one of the following as a video cable:
video cable (3BNC y 3BNC), S-video cable, or
75 Ω coaxial cable.
Note
Use a recorder equipped with a synchronization
function.
1 75 Ω coaxial cable (not supplied)
2 9-pin remote control cable (not supplied)
3 Phono jack cable (not supplied)
4 Cable with XLR connectors (not supplied)
5 S-video cable (not supplied)
Audio input Video input