Filter
Top Products
Chapter 3 Using the Unit as a Player in an Editing System
56 (GB) Chapter 3 Using the Unit as a Player in an Editing System
Adjusting Edit Timing
For details, refer to the instruction manuals of the editing
controller you use.
Using this unit as a player with the RM-
450/450CE
1 Set the SYNCHRO selector to ON.
2 Set item number 3 of the SYSTEM PRESET right
switch to OFF (it is set to OFF at factory).
Setting this to OFF adjusts the synchronization of
the recorder.
3 Execute the LEARN function.
Using this unit as player 1 with the PVE-
500
When using this unit as player 2, the relevant menu
item is indicated in ( ).
1 Set Sync Edt of SEtUP-10 to OFF in the SETUP
menu.
2 Set P1 dELAY (P2 dELAY) of SEtUP-13 (SEtUP-
14) to LEArn in the SETUP menu.
3 Set rEC Sync of SEtUP-15 to On in the SETUP
menu.
4 Set P1 Sync (P2 Sync) of SEtUP-16 (SEtUP-17) to
OFF in the SETUP menu.
5 Execute the LEARN function.
Using this unit as a player 1 with the FXE-
120/120P
• When using this unit as player 2, the relevant menu
item is indicated in ( ).
• When using an FXE-100/100P that has been
upgraded with an FXE-KIT1, the relevant menu item
is indicated in [ ].
1 Display item 104 [301] SYNC GRADE in the
SETUP menu, and set PLAYER1 (PLAYER2) to
PREROLL & PLAY.
2 Display item 301 (302) [401 as player 1, 402 as
player 2] DEVICE TYPE PLAYER1 (DEVICE
TYPE PLAYER2) in the SETUP menu, and set the
VCR device constants.
For details on device constants, see page 47 (GB).
3 Execute the LEARN function.
If the edit timing is out of adjustment, follow the
instruction given in “Adjusting the IN point”
below.
Adjusting the IN point
If the actual edited point does not accurately coincide
with the preset editing point, perform a fine adjustment
of the edit timing using the SETUP menu of the editing
controller. This improves the editing accuracy.
1 Display item 301 (302) [401 as player 1, 402 as
player 2] DEVICE TYPE PLAYER1 (DEVICE
TYPE PLAYER2) in the SETUP menu, and
change it from DISABLE to ENABLE.
2 Repeat the editing process several times and check
the shift of the editing point; that is, count the
number of frames to be adjusted.
Note
The editing results may differ between the
DISABLE and ENABLE settings of SETUP menu
item 301 (302) [401 as player 1, 402 as player 2].
Be sure to check the editing results after changing
the setting to ENABLE.