Filter
Top Products
6
POWER ON AND OFF
The power switch is at the right side of the machine.
POWER ON
Turn the power switch to the "ON"
position.
It takes about several
seconds for the machine
to warm up. The machine
can start copying only
after warm-up.
However, you can
change settings and
press the [COPY
START] key ( ) during
warm-up. The copying
will start immediately
after warm-up.
POWER OFF
Be sure to turn the power switch to the
"OFF" position when it is not being used.
When the machine is
powered off during an
operation, misfeed may
occur, and the task being
processed will be
cancelled.
Auto power shut off
The auto power shut off mode helps to reduce the total power consumption and the running cost. It also helps to
save natural resources and reduces environmental pollution.
If no operation is performed in 3 minutes when the machine is on, the machine will automatically enter auto power
shut off mode (The 100% ratio indicator will flash, and all the other indicators will be off). To restore normal
operation, press any key on the operation panel. The normal mode will be resumed when the machine receives any
printing task.
“ON”
“OFF”
• Upon the startup of the machine, or when the [CLEAR] key ( ) is pressed twice, the machine will be restored
to its initial settings. When the machine is restored to its initial settings, all the settings and selected functions
will be cancelled.
• If no operation is performed in 3 minutes, the machine will automatically enter auto power shut off mode.
• When the machine restores to the initial status after resolving the misfeed, do not turn off the power supply.
Note
Initial setting
Upon the startup of the machine, or when the [CLEAR] key ( )is pressed twice, or when it has been left
untouched for 1 minute after finishing a task, the machine will be restored to its initial settings.
Copy ratio: 100%, Exposure:3
Copy count: 0, All special copier modes: OFF