Filter
Top Products
r
AR-3000 RS-232C Reference -45
Note: When operation is paused with the PE command, the AR-3000 outputs the elapsed
time from the start of the phrase to the point where paused.
The number of digits for **F (frame) increases according to the value of MTC type
= AE ( Auto inc rEc start )
Function: Output the total number of phrases recorded on the card
Syntax: stxAE: S**** ;
a
a the total number of phrases recorded on the card
Note: This is output when AR receives an AE command.
4.4.2 Reply Commands
= ER (ERror)
Function: Replies when an error has occurred.
Syntax: stxER: * ;
a
a Error number
0 Syntax error
This error occurs when correct reception was not possible, such as when the
syntax of the command was incorrect or inappropriate.
1 The specified phrase does not exist, or the phrase number is incorrect. This
error will also be output if a phrase number is specified for a card which is not
inserted.
2 Busy error.
The AR-3000 is currently recording or playing back. When the AR-3000 is
recording or playing back, it will process only the following commands.
Control commands Request commands
During
Recording
PA , ST AC
During Play PA , ST , PE AC
During Play
Pause
PA , ST , PE , RL AC
3 An editing command was received when the AR-3000 was not in Delete mode.
4 This error occurs if a setting/delete/record command is transmitted while the
write protect switch of the card is ON.
5 This error occurs when the total number of phrases specified by the PA, PU, or
CE commands exceeds the maximum value (100), or when the specified
parameter value is outside of the limit of the maximum value.
6 This error occurs when the characters being set for a phrase name or card
name exceed the maximum value.
7 This error occurs when characters other than numerals (0 - 9) are used to
specify an integer.
8 This error occurs when you attempt to specify a previously recorded phrase as
a pattern phrase.
9 This error occurs when you attempt to record or copy a phrase on an already
recorded phrase.
10 There is no remaining card capacity.
20 The command could not be executed for some other reason.