Filter
Top Products
Appendix
76
6
Moving the Printer
R
CAUTION:
Moving the printer in a short distance
A
AA
A
Be sure to check the following points:
• The power switch is turned off.
• The power cable is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
B
BB
B
If the external options are installed, remove them.
See the Option Setup Guide and follow the steps backwards for removing op-
tions.
C
CC
C
Lift the printer with two people by using the inset grips on both side of the
printer, and then move it horizontally to the place where you want to install
it.
D
DD
D
If you removed options in step
B
BB
B
, reinstall them.
Note
❒ See the Option Setup Guide for installing options.
Important
❒ Be sure to move the printer horizontally. To prevent toner from scattering,
move the printer slowly.
❒ If the optional Paper Feed Unit is installed, remove it from the printer, and
then move them separately.
• When lifting the machine, use the inset grips on both sides. Otherwise the
printer could break or cause an injury if dropped.
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
AresPGBMaintGuide-F_FM.book Page 76 Friday, July 26, 2002 5:17 PM