53
5. Troubleshooting
Error & Status Messages on the Control
Panel
❖
❖❖
❖ Status Messages
❖
❖❖
❖ Alert Messages
Messages/Second messages Status
Calibrating… The printer is calibrating the color. Wait until "Ready" appears
on the panel display.
Energy Save Mode The printer is in Energy Saver (low-power) mode. No action is
required.
Hex Dump Mode The printer receives data in hexadecimal numbers in Hex
Dump mode. Turn off the printer after printing, and then turn
it back on.
Offline The printer is offline. Make the printer online by pressing the
{
{{
{On Line}
}}
} key to start printing.
Please Wait The printer is initializing the development unit or HDD. Wait
for a while.
This message may appear when printing with small size paper
continuously.
Wait for a while.
Processing… The printer is processing the print job. Wait for a while.
Ready The default ready message. The printer is ready for use. No ac-
tion is required.
Resetting Job… The printer is resetting the print job. Wait until "Ready" ap-
pears on the panel display.
Waiting… The printer is waiting for the next data to print. Wait for a
while.
Warming Up… The printer is warming up and not ready. Wait until "Ready"
appears on the panel display.
Messages/Second messages Description Solution
Add Toner:
XXX
The printer is out of the indi-
cated toner(s).
XXX: Yellow/Magenta/Cy-
an/Black
Replace with a new toner car-
tridge of the indicated
color(s). Even when yellow,
magenta or cyan toner runs
out, you can print in black and
white using the black toner.
See p.29 “Replacing Consum-
ables and Maintenance Kit”.
AresPGBMaintGuide-F_FM.book Page 53 Friday, July 26, 2002 5:17 PM