Filter
Top Products
E-21
Color
Color mode lamp
Lit Printing will be in color.
Unlit Printing will be in black & white.
Press the Color button and select Color or Black & White.
Press the + button or the − button and select the number of copies.
• When the power is switched on, one copy is selected.
• A maximum of 20 copies can be set and the number of copies is displayed in the display window.
• Each press of the + button increases the number of copies (by one) and each press of the − button decreases the
number of copies. Press and hold the button to switch continuously.
Press the Print button to print.
•
The reading operation is performed for a one-sheet portion (while the sheet is scrolled) and the printing operation is performed.
Note
• If the Feed/Stop button (for model M-115, the ON/Standby button) is pressed while the sheet surface is being
read, printing is interrupted and only part of the image will be printed.
To move the sheet surface, wait until scrolling stops, then press the Feed/Stop button (for model M-115, the
Page change / buttons).
• When the fourth page has been printed, after the reading of the page is completed (i.e., printing is completed),
there will be a return to Page 4.
• When a USB memory has been inserted, a press of the Save button during printing will start the USB memory
storage operation after printing is completed. (See Page E-24.)
• The one-screen portion is reduced to A4 paper size and printed.
For wide type copyboards (model M-11W), the image is compressed about 75% in the lateral direction. To print with the
same proportions as the image on the sheet surface, see “Printing in the same ratio as the sheet surface” (page E-23).
• A flashing “ ” in the display window indicates a print error. See “Meaning of Error Messages” on Page E-34.
When the copyboard is not going to be used, press the ON/Standby button and switch off
the power (standby mode).
• Switch off the printer power.
Note
• If no button is operated for 30 minutes or greater, the unit is set to the sleep mode and the LEDs on the control
panel turn off. If the power button is pressed, the LEDs on the display window turn on. If the print button
is
pressed at this time, the printing operation starts.
Number of Copies
Print
ON/
Standby
Printing