Filter
Top Products
E-11
CAUTION
Please have 2 or more people hold the unit. If the unit is dropped or falls over, this could cause unexpected injury.
Changing the Height of the Unit
This is the height adjustment when setting up the copyboard on the optional stand. The stand height can be
adjusted to 3 levels in 100 mm units.
Lock knob
Stand
Rear frames
Hook
Installation hole
Please lock the casters by pushing the lower portion of the lock button.
(1) Disconnect the power cable and all other connection lines.
(2) Take out the printer and remove the printer tray.
Please loosen the printer guide fastening screws before removing the printer.
Remove the two M4 screws from bottom side of the printer stand and the other two from the rear surface.
(3) Remove the two lock knobs (located at the left and right sides).
(4) Change the hole position of the rear frames.
The copyboard will disengage from the hooks when it is lifted up about 1 cm.
Fully hook the (left and right) installation holes of the rear frames onto the hooks of the stand.
If a stay (for preventing shaking) is mounted on the printer stand, insert the stay in its original position.
(5) Attach the lock knobs to the 2 locations (left and right) and tighten to the rear frames.
(6) Return to original by following the steps in reverse.
Names of the Parts