Filter
Top Products
4.To install the swivel mount, first find a suitable location.The swivel mount’s adhesive is
very strong and may be difficult to remove.Do not install this mount on leather surfaces
and make sure the air temperature is at least 60°F (15°C).
Clean the mounting surfaces with the surface preparation kit. Peel away the adhesive liner
and firmly press the swivel mount to the surface for 30 seconds.Allow 24 hours before
using the mount.
If you need to remove the mount, carefully lift the adhesive pad with your fingers or a
spoon.Warming with a hair dryer for several minutes will help soften the adhesive.
Using Your inno Alone
Using Your inno Alone
25
Using Your inno Alone
24
Using Your inno Alone
5.To install the vent mount, find a horizontal vent that is strong enough to hold your inno
and dock.To remove the vent mount, push it into the vent and lift upwards slightly to
release the mount’s hooks from the vent vane.
6. Find an unused FM frequency on your car stereo.
7. Set your inno to the same FM frequency.(Refer to the section marked “Settings,”“FM
Frequency.”)
8.Tune inno to XM channel 1.You should be able to hear XM through your car stereo.
You can adjust the tension of
the mount with a screwdriver.
enginno_usergd.r1.qxd 3/27/06 6:04 PM Page 24