Filter
Top Products
17
You should be able to hear the »
difference in compression immediately.
Note
The best way to determine which of these •
DRC value settings suits you best is to
experiment with them on a variety of source
material.
Prune
This option will list active stations and remove
any stations that are in the list but have no
service in your area from the service list.
Those invalid stations in the service list have
a question mark (?) displayed in front of the
station name.
1 Select Prune stations and press OK.
All stations that have a question mark »
will be deleted from the service list.
System
• [SW version]: Display software version
of the unit.
• [Factory reset]: Reset all the settings of
this unit to factory default. Press OK to
confirm reset.
Listen to FM radio
Tune to a radio station
1 Press TUNER on the remote control
repeatedly until the desired waveband
(FM) displays.
2 Press SCAN.
The radio automatically tunes to a »
station with sufficient signal strength.
3 Repeat the step 2 until you find the
desired station.
Tip
To tune to a station with weak signal, press •
/ repeatedly until optimal reception is found.
Manual tune
With this feature, you can tune to a specific
channel/frequency manually. In addition to
antenna orientation for better radio reception,
the optimal reception can also be obtained
with this feature.
1 In DAB mode, press MENU to display the
[Manual tune] option.
2 Press OK to confirm the selection.
The display shows a channel and its »
frequency.
3 Press / repeatedly until the desired
channel/frequency appears.
4 Press OK to confirm the selection.
Tip
You can press • INFO/RDS to change the
service information on the display.
You can adjust the position of the antenna to
•
obtain the optimal signal strength.
Dynamic Range Control (DRC)
DRC adds or removes a degree of
compensation for the differences in the
dynamic range between radio stations.
There are three levels of compensation:
• [DRC Off]: No compensation applied.
(the default)
• [DRC Low]: Maximum compensation
applied.
• [DRC High]: Medium compensation
applied.
1 In DAB mode, press MENU to enter the
menu options.
2 Press / repeatedly until[DRC]
displays.
3 Press OK to enter the sub-menu.
The current DRC level displays on the »
first line.
4 Press / to select a DRC value
» [DRC Off], [DRC Low] and [DRC
High] displays on the second line.
5 Press OK to confirm the selection.
English
EN