Filter
Top Products
30
Custom Setup
The common setting for each input selector is explained
below. Go through the following steps for setup.
Tip:
• You can also use the [MENU/ENTER] jog dial on the
CD receiver.
Preferences
ASb (Auto Standby)
When “Auto Standby” is set to “On”, the CD receiver
will automatically enter standby mode if there is no
operation for 30 minutes with no audio signal input.
The ASb indicator lights up when the Auto Standby
function is enabled.
Default setting: On (European models), Off (Other
models)
SleepCharge
You can specify how the power is fed to your USB
device (mobile device) when the CD receiver is in
standby mode.
Note:
• When the “SleepCharge” setting is set to “On”, the
power consumption slightly increases in standby
mode.
• If the iPod/iPhone completely runs out of battery,
charging might not work. In that case you need to turn
the power on again.
Sel Change
When you connect an Onkyo -capable component,
it’s important that you select the input source name that
matches the type of component for to work properly.
Before operating this setting, you need to select the input
source that you want to set.
LINE1, LINE2, OPTICAL, COAXIAL
DOCK
Note:
• “DOCK” can be selected for the “LINE1”, “LINE2”,
“OPTICAL”, “COAXIAL” input selector, but not at
the same time.
Setting Common Preferences
1
Press the [MENU] button, and then use the
Arrow [ ]/[ ] buttons to select the
preference you want to change.
2
Press [ENTER].
3
Use the Arrow [ ]/[ ] buttons to select the
preference’s options.
4
Press [ENTER].
On
Off
On:
(default)
If you connect USB device (mobile
device), charging will start.
“Charging” appears on the display.
Off: Your USB device (mobile device)
is not charged.
→
→