Onkyo CR-555 Portable CD Player User Manual


 
16
Basic Operations
To turn on the CD receiver, press the On/Standby [ ]
button on the remote controller.
Press the On/Standby [ ] button again to set the CD
receiver to Standby.
You can also use the [ ON/STANDBY] button on the
CD receiver.
Tip:
For details on power management settings, see “ASb
(Auto Standby)” (see page 30), “SleepCharge” (see
page 30).
To adjust the volume, use the VOLUME [ / ] button.
You can also use the [VOLUME] control on the CD
receiver.
To select the input source, press the remote controller’s
[INPUT SELECTOR] button. On the CD receiver, press
the [INPUT] button repeatedly. The input sources are
selected in the following order.
(CD receiver)
(Remote controller)
This manual describes the procedure for using the
remote controller, unless otherwise specified.
Turning On the CD receiver
Adjusting the Volume
Selecting the Input Source
CD
LINE1
LINE2
AUX IN
FM
USB
COAXIAL
OPTICAL
AM
DAB
LINE1
LINE2
AUX IN
[LINE]:
OPTICAL COAXIAL
[DIGITAL]:
FM
[TUNER]:
AM
DAB
Adjusting the Tone
1
Press the [TONE] button repeatedly.
Setting will change in the following orders:
Bass, Treble, Balance, PM.Bass, Direct
2
Use the Arrow [ ]/[ ] buttons to adjust the
tone.
Bass, Treble
–3 to 0 to +3 in 1 steps. (The default value is 0.)
Balance
L7 to 0 to R7 in 1 steps. (The default value is 0.)
PM.Bass (Phase Matching Bass)
From the warm low notes produced by a cello to the
deep frequencies of electronic music, a good
compact audio system should be able to deliver
plenty of bass resonance.
While traditional enhancement systems effectively
boost low-frequency sound, they are often prone to
the effects of phase shifting, which can overwhelm
mid-range frequencies and muddy the sound. Our
Phase-Matching Bass Boost technology effectively
preserves mid-range clarity-allowing vocals and
strings to shine-while maintaining a smooth,
powerful bass response at all volume levels.
When the Phase Matching Bass function is on, the
S.Bass indicator appears on the display.
On
Off (default)
Note:
If the PM.Bass function is set to “On”, “Direct”
function cannot be selected. You need to set the
PM.Bass function to “Off” to enable “Direct”
function.
Direct
When the Direct function is on, the tone controls are
bypassed, so you can enjoy a pure sound.
The DIRECT indicator appears on the display.
On
Off (default)
Note:
If the Direct function is set to “On”, the “Bass”,
“Treble” and “PM.Bass” functions cannot be
selected. You need to set the Direct function to
“Off” to enable those settings.