Filter
Top Products
59
5
1
Insert the card into the card slot
until it stops with a click, and close
the card cover.
2
Release the HOLD switch.
3
Insert end A of the USB cable to
your PC's USB port or USB hub.
4
Confirm that the recorder is not in
use before attaching end b of the
USB cable to the terminal port of
the recorder.
“REMOTE” is displayed on recorder if the
USB cable is connected.
REMOTE
Be sure to install the DSS Player software before connecting the recorder to the PC.
However, if you do connect the recorder before or during the software installation, the
“Add New Hardware Wizard” appears, cancel the wizard by pressing the [Cancel] button
in the Wizard screen and then install or continue the installation of DSS Player software.
Connecting to your PC using the USB cable
Connecting to Your PC
Connecting to Your PC
.................................................................................................................................................................
Notes
• NEVER remove the card or disconnect the USB cable while the record/play indicator lamp is flashing.
If you do, the data on the card will be destroyed.
• Refer to the user's manual for your PC regarding the USB port or USB hub on your PC.
• Be sure that you connect the USB cable either directly to the USB port on your PC or the self-power
(AC adapter connection) USB hub.
• Be sure to push the cable connector all the way in. Otherwise, the recorder may not operate properly.
• Release the HOLD switch.
• When the recorder is connected to a PC, the power will be supplied from the USB cable.