Filter
Top Products
DS5 User Guide
[Manual & Standby] Playback mode with quick access to certain files via numeric buttons
on the remote control from 000-999. This mode can be used for kiosks and other digital
signage applications, where users may request certain information with the push of a
button. Reboot the device after you have enabled this function.
When this mode is used, the player will require a title file (000.avi or 000.jpg & 000.mp3)
and up to 999 AVI files, which are played when the numeric buttons are pressed. In
Manual mode, once the AVI file has finished playback, it will return to the title file until
another button is pressed. In Standby mode, it will wait for further user input. Those files
can either be stored on the local hard drive or the CF card.
Button File
000 (title file) 000.avi or 000.jpg & 000.mp3
001-999 001.avi ~ 999.avi
Note: If you use the Manual or Standby mode and there is no 000 file, it will display a
message saying “No Title Files Found”. The same message will appear if the 000 file is
not an AVI or JPG&MP3 file.
Note: Make sure that there is no more than one file with the same file name!
[Auto ON/OFF] Turning this function ON will allow you to set a time for the unit to
automatically turn ON and also a time for it to turn OFF again.
1. Press SETUP on your remote control to enter the DS5’s setup menu.
2. In the MISC2 category, turn on the Auto ON/OFF function.
3. Select the ON/OFF Time and enter a time for each option.
Note: Make sure the NTP server is enabled and the DS5 has a connection to the internet to
synchronise the time. If it can not connect to the internet at boot up, the system time will
be off and the Auto ON/OFF function therefore inaccurate.
Page 46 / Chapter 4 - Playback