Filter
Top Products
DS5 User Guide
5. Fasten the screws from the bottom to
mount the drive to the framing.
6. Place the assembled drive back in the
plastic framing and connect the cables.
7. Mount it on the heat sink by fastening
the screws.
8. Align the top cover with the body and
push lightly into place.
Note: Be careful not to damage any cables or components during the installation! The
additional metal sheet is not required for the 2.5” HDD. Store it in a dry place until you
install a 3.5” HDD.
Page 11 / Chapter 2 - Hardware Installation