Filter
Top Products
3
TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
TRANSMITTER (INSTALL BATTERIES IN TRANSMITTER BEFORE
INSTALLING BATTERIES IN RADIO-CONTROLLED CLOCK)
The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please
follow the steps below:
1. Remove the battery cover by pushing down towards bottom of transmitter and sliding
cover out.
2. Insert the batteries, observing the correct polarity (see marking inside battery
compartment).
3. Replace the battery cover on the unit.
ALKALINE BATTERIES ARE RECOMMENDED FOR USE IN BOTH UNITS. AVOID USING
RECHARGEABLE BATTERIES.
TO INSTALL AND REPLACE BATTERIES IN THE RADIO-CONTROLLED
CLOCK
The radio-controlled clock uses 2 x AA, 1.5V batteries. To install and replace the batteries,
please follow the steps below:
1. Remove the battery cover.
2. Insert batteries observing the correct polarity (see marking inside battery
compartment).
3. Replace compartment cover.
DO NOT SET THE CLOCK.
Note:
In the event of changing batteries of the unit, ensure that the batteries do not spring free
from the contacts. Always wait at least 15 minutes after removing the batteries before
reinserting, otherwise start up and transmission problems may occur.
REPLACEMENT OF BATTERIES
For best performance, batteries should be replaced at least once a year to maintain the best
running accuracy. Ensure that the batteries used are new and the correct size.
Please help in the preservation of the environment and return used
batteries to an authorized depot.