Filter
Top Products
15
surrounding temperature. Current surrounding temperatures are
outside measuring range.
Problem:
"--.-" appears in the outdoor temperature section of the LCD.
Solution:
1) Remove the batteries of both units for ten minutes, then reinsert
them again. Make sure the batteries are new and fresh. See
setting- up.
2) Move the radio-controlled clock closer to the transmitter or place
the transmitter closer to the radio-controlled clock. Make sure the
clock is at a receivable range from the transmitter.
3) Move the units to another location. Interferences from other
electrical devices operating on the same signal frequency (433MHz)
may prevent correct signal transmission and reception.
Problem:
"OF.L“ appears in the outdoor temperature section of the LCD.
Solution:
1) Wait until the current surrounding temperature cools down or
increases. Current temperature is outside of the measuring range of
the transmitter or has temporary affected battery strength. The
outdoor temperature will be displayed again once the current
surrounding temperature is within the range of the transmitter.
CARE AND MAINTENANCE:
• Avoid placing the units in areas prone to vibration and shock as these may cause
damage.
• Avoid areas where the units can be exposed to sudden changes in temperature, i.e.
direct sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes
which reduces the accuracy of readings.
• When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or
scouring agents.
• Do not submerge the units into water.
• Immediately remove all low powered batteries to avoid leakage and damage. Replace
only with new batteries of the recommended size.
• Do not make any repairs to the units. Please return it to the original point of purchase.
Opening and tampering with the units may invalidate the warranty.