Filter
Top Products
19
5. Position the remote temperature/humidity sensor in
the desired location, ensuring that the indoor
weather station can receive the signal.
C. MOUNTING USING THE STAND
The mounting bracket can be used as a stand by simply
attaching the bracket to the bottom of the temperature/
humidity sensor. Once snapped in place the sensor can
then be placed on a shelf, table or other surface where
the temperature and humidity measurements are
desired.
II. THE INDOOR WEATHER STATION
The indoor weather station can be mounted in two ways:
• with the table stand
• on the wall with the use of a wall hanging screw (not
included).
A. USING THE TABLE STAND
The indoor weather station comes with the table stand
already mounted. If you wish to use the table-stand all
that is required is to place the indoor weather station in
an appropriate location.
B. WALL MOUNTING
1. Remove the table-stand. To do this, pull down on
the stand from the rear and rotate forward.
2. Fix a screw (not included) into the desired wall,
leaving approximately 3/16 of an inch (5mm)
extended from the wall.
3. Place the indoor weather station onto the screw
using the hanging hole on the backside.