Filter
Top Products
17
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and
operating instructions.
B. VIEWING AND OPERATING WITH MULTIPLE
REMOTE TEMPERATURE SENSOR UNITS
1. To view the temperature of a different remote
temperature/humidity sensor unit, press and release the
IN/OUT, SET/CH button. A shift from one “boxed” number
to the next should be observed just below the temperature and
humidity display.
2. To view the minimum/maximum temperature/humidity: first
select which remote temperature/humidity sensor to read data
from (indicated by the “boxed” number), then follow the steps
listed on page 14 – 15 in the “Viewing The Outdoor
Temperature/Humidity Records” section.
1. To reset the minimum/ maximum readings, it is necessary to
select which remote temperature/ humidity sensor you wish to
reset. Next select the minimum or maximum record that you
wish to reset. Finally press and release the IN/OUT, SET/CH
button to reset the selected record.
MOUNTING
Note: Before permanently mounting ensure that the indoor weather station
is able to receive signals from remote temperature/humidity sensors at the
desired location. Also, extreme and sudden changes in temperature will
decrease the accuracy of the indoor weather station. To achieve a true
temperature reading, avoid mounting where direct sunlight can reach the
remote temperature/ humidity sensor or indoor weather station. While the
remote temperature/ humidity sensor is weather proof, avoid submersion in
water or snow. We recommend that you mount the remote temperature/
humidity sensor on an outside North-facing wall. The sending range is
80ft—obstacles such as walls, concrete, and large metal objects will reduce
the range. Place both units in their desired location, and wait approximately
15 minutes before permanently mounting to ensure that there is proper
reception. The indoor weather station should display a temperature/