Filter
Top Products
9
data signal from the sensor. The outdoor
temperature and humidity should then be
displayed on the Temperature Station. If
this does not happen after 2 minutes, the
batteries will need to be removed from
both units and reset from step 1 and the
signal reception icon is no longer shown.
A. REMOTE TEMPERATURE SENSOR
Remove the mounting
bracket.
a. Remove battery
cover
b. Observing the
correct polarity,
install 2 AA
batteries—make
sure they do not
spring free, or start-up problems
may occur. Replace cover.
B. INDOOR TEMPERATURE STATION
Note:
After the batteries are installed, DO
NOT press any buttons. This may interfere
with the signals, causing temperatures to
register incorrectly.
Battery
cove
r