Filter
Top Products
32
KH 2370
33
KH 2370
If folders exist:
With this function you can select certain les in the current
sub-folder for programmed playback. You can determine
the order in which the les are played back.
To operate the programmed playback function, go to the
corresponding chapter and continue reading.
SINGLE
The currently selected le is played back once.
REP-ONE
The currently selected le is played back repeatedly. The
repeat playback is continued until you stop the playback
by pressing the STOP button.
Selecting playback mode
1 If a le is being played back, rst of all stop the play-
back with the STOP button.
2 Change from the list of the les to the mode selection
bar with the right control button. Firstly the FOLDER
playback mode is selected automatically.
3 You switch through the dierent playback modes with
the up and down control buttons.
4 If the required playback mode is displayed, then exit
the mode selection bar with the left control button.
The marking is now in the list of the les of the select-
ed sub-folder again.
5 To start the playback in the set mode, press the PLAY
button. The playback starts with the marked le in the
list of les.
Programmed playback (Program)
If you have selected the PROGRAM PO mode, to select sev-
eral les for programmed playback:
1 Change back to the list of the les of the current sub-
folder using the control buttons.
2 Select the rst le to be programmed using the control
buttons.
Note:
If folders exist: You can only select les for programmed
playback from the currently selected sub-folder. Files
from dierent sub-folders can not be selected for pro-
grammed playback.
3 Conrm the selection by pressing on the ENTER button
on the remote control. The selected le is now dis-
played as the rst programmed le on the top of the
SMART NAVI menu,.
Example: If you have programmed the fth le (in the
current sub-folder), then Program 01:0005 is displayed.
4 Repeat steps 1 and 2, until all required les have been
programmed.
5 Then press the STOP button. PROG-END is displayed in
the mode selection bar.
6 Press the PLAY button to start the playback of the pro-
grammed les.
7 To delete the programmed playback, change to anoth-
er playback mode.
Cleaning the
combination unit
Clean the casing of the combination unit only with a
slightly damp cloth and a mild detergent. Pay attention
that no moisture enters into the combination unit!
Clean the inside of the disc tray – if necessary – only with a
clean dry brush (e. g. lens brush, can be bought in special-
ised camera shops). Never clean the inside of the disc tray
with a wet cloth!
Warning!
If moisture penetrates into the combination unit, there
is a risk of getting an electric shock! In addition this can
cause irreparable damage to the combination unit!
To rectify malfunctions
and errors
Nothing appears on the display/
combination unit shows no function,
although it is switched on
A Check whether the power cord has been plugged into
the power socket properly.
B Check whether the power socket, in which you have
plugged the power cord of the combination unit, has
electric current, by connecting another device to the
power socket. If necessary, plug in the power cord of
the combination unit into another power socket.