Filter
Top Products
18
To start scanning, press the
Side 2
key.
• The LED indicator ashes green and scanning starts from the current
channel and ascends through the channel numbers.
• When a signal is detected on a channel and the QT/DQT matches,
scan pauses at that channel and the LED indicator lights green.
• When the signal is no longer present, scanning continues after 3
seconds (default).
To end Scan, press the
Side 2
key again.
■
Temporary Delete
You can temporarily remove specic channels from the
scanning sequence during Scan. When Scan pauses at a
channel, you can remove that channel from the scanning
sequence by pressing and holding the
Side 2
key for
3 seconds.
• You cannot remove a channel if there will be less than
2 channels available for scanning remaining.
• To add the removed channels back into the Scan list, simply exit
Scan mode or switch the transceiver power OFF and then ON
again.
TK-3200L (K3) Model:
The default function of the
Side 2
key is Calling Alert.
Calling alert tones are used to identify yourself to your party
members and inform them that you are about to make a call.
To make a call using the calling alert tone, press and hold the
PTT
switch, then press the key programmed as
Side 2
.
• The calling alert tone will transmit for the duration you press the
Side
2
key.
Note:
The
Side1
and
Side2
keys can be reprogrammed {page 31}.