12
inStAlling the cAp over the SpeAker/ microphone JAckS
inStAlling the optionAl SpeAker/ microphone (or heAdSet)
If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks
using the supplied 3 x 6 mm screw.
Note: To keep the transceiver
water resistant, you must cover the
speaker/ microphone jacks with the
supplied cover.
2
1
2
Attach the locking bracket using
the supplied 3 x 6 mm screw.
Note: The transceiver is not fully
water resistant while using the
speaker/ microphone.
Insert the speaker/ microphone
(or headset) plugs into the speaker/
microphone jacks.
Note: Always switch OFF the
transceiver power when installing
or removing a speaker/ microphone
or headset.