JVC LYT0002-0H6B MP3 Docking Station User Manual


 
EN 65
TROUBLESHOOTING
Error
This application will
close.
Check devices
Confirm
that power is ON.
No devices detected to
connect.
Power ON all devices in
system.
Communication error
(&H
(number))
Check cable connection.
Select the device to control.
No video cassette!!
Load a video cassette to ID
(number).
Invalid entry in scene
(number) (There is IN > OUT
condition). Correct the time
or delete the scene.
Select a number between 0
and 24.
Invalid frame number on drop
frame counter.
The COM port used for the JLIP connector is not
selected, or the COM port is selected but the
connection is wrong.
Check the connected COM port and select it on the
"Serial Port Selection" screen ( pg. 46).
Power is not supplied or the connection is wrong.
Connect the devices correctly and turn them on
(
pg. 42, 43).
Device is not turned on or cable is disconnected.
Connect the device correctly and turn it on
(
pg. 42, 43).
If device was turned off and on again during
operation, click "OK". All devices should function
properly.
The line where the name of the device to use
appears is not clicked.
Click on it and "OK" ( pg. 47).
The video cassette is not loaded in the camcorder.
When the video cassette is removed during
operation, this message appears.
Insert the video cassette into the camcorder.
The value of the CUT OUT point is smaller than
the CUT IN point's.
Set the value of the CUT OUT point so that it is
larger than the CUT IN point's ( pg. 50, 54).
When correcting the CUT IN/OUT points, the
value you set differs from the original by over 25
frames.
Select integral number from 0 to 24 ( pg. 54).
Because the DV-format digital camcorder uses the
drop frame system, inputting frame 00 and 01 is
impossible.
Input frame value other than 00 or 01
(
pg. 48, 54).
MESSAGE
POSSIBLE CAUSE
CORRECTIVE ACTION
The monitor displays of the application software illustrated in this manual may differ from
those you are actually viewing depending on the operating environment of your computer.