Filter
Top Products
64 EN
ADVANCED OPERATIONS
(cont.)
Adjusting the gap between the stored edit-start point in the computer and the
dubbed one in the recording deck
During dubbing, the beginning of the scene stored in the computer can be missed or the scene
prior to the transition you chose for the edit-start point can be dubbed into the recording deck.
When these cases occur, adjust the gap for more accurate editing.
4
DETERMINE VALUE
Click "OK".
•This value is stored in the computer.
5
CHECK EDIT-START TIMING
AGAIN
To check the corrected edit-start timing,
dub the stored scenes and play them
back.
NOTE:
Even if the edit-start timing is adjusted, there
can be a slight margin between the adjusted
edit-start point and the dubbed scenes' one.
MOVIE PLAYER
FILE
POWER
PROGRAM PLAYBACK
COUNTER
Drop
MEMO
ID
SCENE
CUT IN CUT OUT
STARTSCENE
ELAPSED TIME
00:10:04:28F
IN/OUT
OFFON
MODE
STILL
PLAY
SEARCH
SLOW
FF
REW
00:00:01:20F
06
01
02
03
00:01:30:12F
00:07:15:21F
00:15:50:11F
00:03:27:14F
00:10:40:18F
00:20:33:10F
File Video Printer HelpEdit
travel
Europe Tour
New
Open
Save
Save As...
ID Change
Device Change
Name Change
Pause Time...
Open VCR Control Window
Close Serial
Initialize
Counter Reset
Exit
Ctrl+N
Ctrl+O
Ctrl+S
Ctrl+A
File
Pause Time Correction
OK
CANCEL
Type in the value from 0.00(sec) to 2.60(sec),
to adjust pause time during editing.
Pre-start time = 1.30 (sec)
1
CHECK EDIT-START TIMING
After dubbing (੬ pg. 52), play back the
dubbed scene.
2
ACCESS "PAUSE TIME CORREC-
TION" DIALOG BOX
Choose "Pause Time" from "File" on the
MOVIE PLAYER window.
•The "Pause Time Correction" dialog box
appears.
3
ENTER VALUE
To adjust the edit-start timing, enter a
new value from 0.00 sec. to 2.60 sec.
When the scene prior to the transition
you chose for edit-start point is dubbed:
Enter a smaller value than 1.30.
When the beginning of the scene stored
in the computer is missed:
Enter a larger value than 1.30.
•Factory preset is 1.30 sec.