Filter
Top Products
– 15 –
English
Adjusting the Volume
You can adjust the volume level only while the unit is
turned on.
When using the remote control, press VOLUME + to
increase the volume or press VOLUME – to decrease it.
When using the unit, turn VOLUME clockwise to increase
the volume or counterclockwise to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
If “CANNOT LISTEN” appears in the main display
During high-speed recording (see page 30), you cannot listen to
any source, and therefore, cannot adjust the volume level.
For adjusting the recording level
Normally, the VOLUME control and VOLUME +/– buttons work
to adjust the playback sound volume.
If you want to adjust the recording level, see “To adjust the
recording input level” on page 32.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
Ex.: When setting the volume level to “20”
UNFINALIZE
DISC
SLEEP
RDS
EON
[
TA
N
ews
I
n
f
o
]
d
B
REC LEVEL
PITCH
UNFINALIZE
DISC
REC
Changing the Display Information
You can change the information in the main display.
• For display information while recording, see “To change
the display information while recording” on page 32.
On the remote control ONLY:
Press DISPLAY repeatedly.
• Each time you press the button, the information in the
main display changes as follows:
■ When the source is CD Recorder:
• Before playing—
• While playing—
■ When the source is other than CD Recorder:
When the current playback source is a CD Text in 3-
CD Changer
See “To show the text information recorded on a CD Text” on page
25.
Reinforcing the Bass Sound
The richness and fullness of the bass sound is maintained
regardless of how low you set the volume—Active Bass.
• You can use this effect only for playback, but not for
recording.
On the remote control ONLY:
Press BASS so that “ACT-BASS ON” appears in the
main display.
The BASS indicator also lights on the display.
• Each time you press the button, Active Bass turns on and
off alternately.
To cancel the effect, press the button again so that
“ACT-BASS OFF” appears in the main display (and the
BASS indicator goes off).
Source
indications
Clock
Track number/
Elapsed playing time
Clock
Remaining time
in the disc
Clock
Total track number/
Total playing time
NORMAL
SPEED
d
B
REC LEVEL
321
BASS
CD
ACT-BASS ON
ACT-BASS OFF
EN13-16_NX-CDR7[J_C]_4 01.9.14, 3:41 PM15