Filter
Top Products
Filename [XVS44U_06Index.fm]
Masterpage:Left+
16
EN
Page 16 9 September 2003 9:51 am
INSTALLING YOUR NEW UNIT (cont.)
Component Video
Connection
(DVD deck only)
8
To connect to a TV with component video input
connectors . . .
A
Connect the unit to TV.
A
Connect the aerial, unit and TV as per “AV
Connection”. (
੬
pg. 14)
B
Connect the unit’s COMPONENT VIDEO OUT
connectors to the TV’s component video input
connectors.
B
Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet. This
unit performs Plug & Play Set automatically. (
੬
pg. 17)
● The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet. (If “AUTO” and the channel
indicator are displayed on the front display panel before the
unit is powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the unit.)
C
Set the VCR channel to off.
A
Press
POWER
(
1
) to turn off the unit, then press
STOP
(
8
) on the unit for more than 5 seconds. “3 CH”
appears on the front display panel.
B
Press
CH +/–
on the Remote to select “– CH” (off),
then press
OK
.
NOTES:
● You can obtain high-quality component video pictures when
you play back discs on the DVD deck.
● If your TV is not stereo-capable, use the unit’s AUDIO
OUTPUT (DVD/VCR) connectors to connect to an audio
amplifier for Hi-Fi stereo sound reproduction.
● To operate the unit with your TV using the Component Video
connection, set your TV to its AV mode. You can also use the
TV/VCR
button on the unit’s Remote to set your TV to the AV
mode. (
੬
pg. 73)
● For switching the TV’s mode, refer to the instruction manual of
your television.
A
TTENTION
Be sure to connect the unit’s VIDEO OUTPUT (DVD/
VCR) connector to the TV’s VIDEO input connector.
TV
To Component Video
Input connectors
Component
Video cable
(not supplied)
Audio/Video
cable
(not supplied)
AC outlet
AC power cord
Back of unit
RF cable
(supplied)
COMPONENT
VIDEO OUT
Antenna or Cable
Matching transformer
(not supplied)
Coaxial cable
Flat feeder
VIDEO OUTPUT
AUDIO
OUTPUT
VHF/UHF
OUT
VHF/UHF
IN
To 75 ohm
Ter minal
Before performing the following steps:
●
Make sure there is no cassette inserted in the unit.
●
Make sure the unit is turned on, then press
VCR/
DVD
on the unit or
VCR
on the Remote so that the
VCR indicator lights up.
XVS44U_06Index.fm Page 16 Tuesday, September 9, 2003 9:51 AM