Filter
Top Products
Masterpage:Right+
EN 77
Filename [DR-MV1SUJ_10Subsidiary.fm]
Page 77 June 10, 2004 9:47 am
SUBSIDIARY SETTINGS
The VCR Plus+ programing system assigns a VCR Plus+ guide
channel to the TV channels and the cable channels. These guide
channel numbers are also called the VCR Plus+ channel codes.
Most TV listings have a section, usually a chart, indicating the
guide channel numbers assigned to each station.
To ensure that VCR Plus+ timer recording operates correctly, it is
necessary to set the VCR Plus+ “Guide Channel Set” for each
station.
If you have moved to a different area or if a broadcasting station’s
channel number has been changed, perform the following steps to
set the correct guide channel number.
NOTES:
● In many instances, the VCR Plus+ guide channel numbers for cable
and broadcast TV stations DO NOT match the channel number on
which it is received by your unit or cable box. Check your TV listing,
or contact your cable supplier for details.
● Many TV stations can be viewed on cable. Check your TV listing, or
contact your cable supplier for details.
Guide Channel Number Set
1 Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
2 Press SET UP to access the Main Menu screen.
3 Press we to select “INITIAL SET UP”, then press ENTER.
4 Press we to select “TUNER
SET”, then press ENTER.
5 Press rt to select “GUIDE
CHANNEL SET”, then press
ENTER.
6 Press rt to select “GUIDE CH”,
then press ENTER.
7 Press rt to select the Guide
Channel number for the desired
station as shown in the TV listings.
Then press ENTER.
● To change the Guide Channel
number in 10 increments, press and
hold rt.
● If you receive your channels with a cable box and if you have properly
set your Controller, “CATV CH”appears in place of “DVD CH”. If not,
perform “Cable Box and/or DBS Receiver Control Setting (DVD Deck
Only)” (੬ pg. 22).
8 Press rt to select “DVD CH”, then press ENTER. Press rt
to select the number of the unit’s channel position on which the
Guide Channel number’s broadcast is received by the unit or the
DBS receiver. Then press ENTER.
● To timer-record a satellite program with the VCR Plus+ system, you
need to install the Controller and perform the procedure described in
“Cable Box and/or DBS Receiver Control Setting (DVD Deck Only)”
(੬ pg. 22).
● Repeat steps 6 and 8 as necessary.
9 Press SET UP to complete the setting.
Changing VCR Plus+
®
Setting
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
1
4
7
2
5
8
0
3
6
9
ENTER
SET UP
rtw e
VCR/DVD
Guide Channel Number
“Guide Channel (GUIDE CH) number” refers to the assigned TV
station numbers, according to broadcast area, for the VCR Plus+
timer recording. The Guide Channel numbers can be found in
most TV listings.
DR-MV1SUJ_00.book Page 77 Thursday, June 10, 2004 9:48 AM