Jensen JiMS-525i MP3 Docking Station User Manual


  Open as PDF
of 24
 
- 7 -
AMoutdoor
antenna
AMloop
antenna
Antenna
DischargeUnit
(NecSection810-20)
ElectricService
Equipment
AntennaLeadInWire
GroundClamp
GroundingConductors
(NecSection810-21)
GroundClamps
PowerServiceGroundingElectrodeSystem
(NecArt250,PartH)
Nec-National
ElectricalCode
GETTING STARTED (Continued)
Connecting FM / HD Radio
TM
Receiver
Antenna / to a Cable Radio Signal
This Radio's FM Antenna Connector is a standard connector that will accept
either the FM Antenna wire (included) or the cable FM feed from most cable
systems that provide FM programming. To connect the included FM Antenna
wire, slide the black plastic end of the antenna wire onto the center post of
the antenna connector on the back of the unit. To connect your Radio to the
FM signal available from some cable TV providers, contact your cable TV
provider for assistance and also to find out if HD Radio
TM
broadcast signals
are available through the cable line. As of the writing of this manual, HD
Radio
TM
signals are not being rebroadcast via cable providers.
Be sure that the installation includes a splitter that will filter the signal to prevent any
re-emission of the TV spectrum through the Radio, so that only the FM band, not the
cable TV signal, is transmitted to the Radio.
Antenna Grounding
Example of antenna grounding, per the National Electrical
Code, ANSI/NFPA 70.
Notice for Cable TV System Installer
Please make note of Article 820-40 of the NEC
(of USA) that provides guidelines for proper
grounding. In particular, this standard specifies
that the cable ground shall be connected to the
grounding system of the building, as close to the
point of cable entry as is practical.
Connecting the AM Loop Antenna
If AM reception is weak for improvement connect the provided Loop
Antenna as describe below:
1. Push to open the 2 receptacles of the AM antenna terminals and
insert 2 open-end wires of the AM loop antenna into them.
2. Release the 2 AM antenna terminal handles to hold the AM loop
antenna wires in place.
3. Orient the AM loop antenna for the best reception.
AUX LINE-IN Connection
Connect one end of the Audio line cable (Included) to the AUX Input jack at the back of the Radio and
the other end of the Audio line cable to your external audio player, such as a CD, MP3 etc.
FM/HDRADIO
ANTENNAWIRE
FM/HDRADIO
ANTENNA
CONNECTOR
AMRADIO
ANTENNA
CONNECTOR
JENSEN JIMS-525i_Eng ib_Rev.p65 5/15/2008, 5:51 PM7
 previous next