Filter
Top Products
- 9 -
RADIO OPERATION
The following procedures can be accomplished by using either the remote or the controls on the main
unit.
Listening to the Radio
Note: When entering the Radio function mode, the words "PLEASE WAIT TO TURN ON RADIO" will
appear first on the bottom row of the Display and then the Band and Frequency Reading will be
shown in the Display after one or two seconds.
1. Press the Button to turn on the unit.
2. Press the FUNCTION Button to operate the unit in radio mode.
TO: PRESS:
Switch between AM/FM band BAND Button repeatedly
Select FM MONO or ST mode SET Button repeatedly
Scan radio station automatically or Hold Buttons for 1 second
Stop auto-tuning or Buttons again
Scan radio station manually or Buttons repeatedly
Control the volume VOLUME + or – Buttons
Adjust the EQ EQ Button repeatedly until the desired EQ shown in the Display
Stop output from the speakers MUTE Button once
Resume output from the speakers MUTE Button again
Note:
1. Frequency reading will change to the time 1 minute after the system has entered the radio function
mode. The FM Stereo Indicator will stay on in the Display in FM stereo mode.
2. To check the station frequency, press the SET/FM MODE Button once and again in order to keep the
station in stereo mode. Station frequency will be displayed for about 1 minute and revert to current
time again.
3. When listening to an FM station, fully extend the antenna to insure maximum tuner sensitivity.
4. Automatic tuning depends on the signal strength of the broadcasting station, so weak stations are
sometimes skipped. Tune manually to find the weak stations. With stronger stations, the tuner may stop
before it reaches optimum setting for that station. Adjust manually for the best reception if needed.
5. For FM reception, the Radio provides FM MONO/STEREO selection. In stereo mode, the unit will
automatically switch to stereo when a strong FM stereo broadcast is received and will indicate "ST" in
the Display.
6. To receive a weaker (noisy) FM station, press the SET/FM MODE Button to switch to MONO mode.
The reception may improve, but the sound heard is monaural (MONO).
7. The sound equalization can be adjusted for optimum sound reproduction depending on the style of
music you are playing. By pressing the EQ button, you can switch between ROCK, POP, CLASSIC,
JAZZ, BASS or NORMAL equalization to suit your taste.
Radio iPod
Aux
Rock Pop
Classic
Jazz Bass Normal
JENSEN JIMS-525i_Eng ib_Rev.p65 5/15/2008, 5:51 PM9