Filter
Top Products
7
4. The mounting bracket is designed to trap the flange of the JBL Control NOW
speaker by securing the mounting-bracket cap with two screws through the
bottom of the mounting bracket. Rest the JBL Control NOW speaker’s rear
flange in the mounting bracket, as shown. This will support the weight of the
speaker. Now slide the mounting-bracket cap over the assembly. Secure the
mounting-bracket cap by inserting two #10-32 x 2" screws (provided) in the
bottom of the mounting bracket and tightening.
5. To orient the JBL logo into the correct position, pull the JBL logo slightly
outward from the speaker grille and rotate. The JBL logo is held in place by
a spring. Peel the adhesive cover off the mounting-bracket cover and attach
to bottom of mounting assembly.
Mounting-Bracket Cover
Mounting Bracket
shownas looking through
the speaker.
To p Ca p
Mounting Bracket
#10-32 x 2"Screws (2)
Ceiling line
Mounting-Bracket Cap
MountingBracket
#10-32 x 2"Screws (2)
(side view)
(side view)
JBLP2605_CN_CNAW_PM-OM 4/23/08 12:57 PM Page 7